5
Slide the replacement power supply into the empty slot (D in Figure 60). The
power supply begins to engage the midplane with 3/8 inch (8mm) still
exposed.
6
Rotate the handles back toward the center of the power supply module to
draw the power supply the last 3/8 inch into the chassis and firmly seat the
power supply on the midplane. The power supply should be flush with the
edge of the chassis.
7
Tighten the thumbscrews on the power supply handles (A and B). It is
recommended that you use a screwdriver to ensure proper seating.
8
Plug the power cord into the power supply and electrical source.
9
Monitor the power supply LED. It should turn green. If the LED is dark or
stays amber, see Chapter 4, Troubleshooting.
Removal and Replacement 121
Need help?
Do you have a question about the StorageWorks 2405 - Disk System and is the answer not in the manual?