Install The Disk System - HP StorageWorks 2405 - Disk System User Manual

Install the Disk System

1 Remove the power supply/fan modules to prepare the disk system for lifting:
a Loosen the screws in the extractor handles of each power supply/fan
module with the chassis still in the box.
b Pull the extractor handles out from the center of the power supply to
disengage it from the midplane. Pull each power supply/fan module out of
the chassis. Support the far end of the power supply/fan module with your
free hand as it clears the chassis.
c Set the power supply/fan modules aside, on an antistatic pad, to be
reinstalled later.
WARNING An empty disk system weighs approximately 54 pounds (24.5 kg).
To avoid personal injury, it is recommended that two people install
the storage device in the rack.
2 Remove the disk modules from the disk system. Place them aside on the pink
antistatic foam pad supplied with your disk system.
3 Carry the disk system to the front of the rack and slide the back end onto the
rails (Figure 35) with the help of another person or using a lifting device.
Push the disk system into the rack as far as it will go.
Installation 63