Interpreting Status Values; Table 12 Status Indications - HP StorageWorks 2405 - Disk System User Manual

Interpreting Status Values

100 Troubleshooting
Enclosure ID
WW Name (node)
WW Name (port)
Firmware Rev.
Power Supply Status
Voltage Sensors
Voltage and Status
Temp Sensors
Temperature and Status
SAM and STM report status in common terms, which are defined as follows:
Table 12. Status Indications
Reported Applicable
Status Component
OK All replaceable
components and
sensors
The unique manufacturer number that
distinguishes the reporting LCC from all other
LCCs.
The World Wide Name assigned to this disk
system. In normal operation, this value is the same
as the World Wide Name (port) for LCC A.
The World Wide Name of the reporting LCC.
The current firmware version on the reporting
LCC.
The status of the left (Supply A) and right (Supply
B) power supplies in the selected disk system.
Possible values are OK, critical, not installed, or
not available.
The voltage detected and status of three voltage
sensors—3.3V, 5.0V, and 12V—on each LCC.
Possible status values are OK, critical, noncritical,
not installed, unknown, and not available.
The temperature detected and status of four
sensors. Possible status values are OK, critical,
noncritical, not installed, unknown, or not
available.
Component is installed and no error
conditions are known.
Indication