Upgrading The Rack (Lh 3R) Configuration; For Hp Racks; For Non-Hp (Compaq) Racks - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 1

Upgrading the Rack (LH 3r) Configuration

You can upgrade the LH 3r rack configuration without removing it from the rack,
but you may find it easier to reinstall the CPU baseboard and install the chassis
reinforcement bars when the LH 3r is removed from the rack and sitting on a
workbench. When in the rack, the chassis reinforcement bars mount on the bottom
of the LH 3r. If you do decide to remove it from the rack to perform the upgrade,
refer to the documentation below.
CAUTION
Do not pull the LH 3r forward in the rack without extending
the anti-tip foot. If the anti-tip foot is not extended, the rack
assembly can tip over and injure you and damage the
NetServer or rack.

For HP Racks

Refer to the HP NetServer LH 3/LH 3r User Guide. For cabling instructions, refer
to the documentation that came with the rack, and to the Rack Cabling Reference
for the HP NetServer LH 4.

For Non-HP (Compaq) Racks

Refer to the HP NetServer LH 3r Installation Guide for Compaq
Racks. For cabling instructions, refer to the documentation that came with the
rack, and to the Rack Cabling Reference for the HP NetServer LH 4.
10
Introduction
®
4000/7000