Hp Netserver Lh 3R - Compaq Rack Precautions - HP LH 3r Installation Manual

Compaq 4000/7000 racks

Hide thumbs Also See for LH 3r:

Table of Contents

Chapter 1

HP NetServer LH 3r – Compaq Rack Precautions

CAUTION

If this NetServer is not installed according to these

instructions, damage to the NetServer or accessories may

result. Damage due to improper installation is not covered by

the HP Warranty. Observe the precautions listed in this

section to maintain the NetServer's reliability.

When the HP NetServer LH 3r is installed in a Compaq rack enclosure, certain

requirements must be addressed to assure that the needs of the NetServer are met.

This NetServer will meet the requirements designed for the NetServer if:

The NetServer is installed in a Compaq model 4000- or 7000-series rack

enclosure. This NetServer is not supported in any other non-HP rack

enclosure.

If you choose to use a door on this enclosure, only a Compaq model 4000-

or 7000-series door may be used. No other door may be used. The

enclosure may be used with the door open, closed, or removed.

Mass storage devices listed in the Tested Products List (located on the

HP NetServer Navigator CD-ROM) are used exclusively in the NetServer.

Use HP rack accessories. (Note that HP rack accessories are not optimized

for Compaq rack enclosures.)

Compaq rack accessories have not been tested with HP NetServer

products, but components such as monitors, keyboards, switchboxes, and

PDUs often work.

Use APC

uninterruptible power supplies (UPS) with HP NetServers.

APC offers mounting kits for Compaq rack enclosures.

This NetServer is not supported in a rack enclosure under circumstances other

than those listed above.

See the "Warranty and Support" section of this document for additional support

considerations.

Introduction

Table of Contents