Finishing The Hardware Upgrade - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 3

Finishing the Hardware Upgrade

As the last step in the LH 3/LH 3r to LH 4/LH 4r upgrade, attach the new
nameplate to the top of the front surface of the front bezel, as follows:
1. Orient the nameplate so that it can be read correctly when attached.
2. Secure the nameplate to the front bezel, as follows:
For the LH 4, pry off the LH 3 nameplate in the upper left corner, then
snap the LH 4 nameplate into place.
For LH 4r with the HP rack front bezel, insert the tab at one end of the
nameplate into the slot in the bezel, bend the nameplate slightly, and
simultaneously insert the snaps on the back of the nameplate and the tab
at the other end of the nameplate.
For the LH 4r with the Compaq rack front bezel, insert the snap at one
end of the nameplate, and then insert the other snaps successively.
3. Attach the label reading "intel inside pentium II xeon" to a convenient
location near a corner of the front bezel.
Installing LH 4 Components
27