Installing The 4 Gb Memory Board - HP D7171A - NetServer - LPr Installation Manual

Chapter 2
7. Place the DIMM in its anti-static container.
8. Repeat steps 5-7 for as many SDRAM DIMMs as you need to remove.
9. If necessary, remove SDRAM DIMMs and reinstall in new slots to match
the DIMM slot configuration for the downsized memory. (See Figure 2-2.)
CAUTION
Close all retaining clips on the 4 GB memory board before
inserting it into your NetServer. This includes clips on empty
slots as well as those on slots containing DIMMs. This
facilitates insertion of the memory board.
10. Install the memory board in the satellite chassis (See the section entitled

Installing the 4 GB Memory Board).

Installing the 4 GB Memory Board
Once you have installed the SDRAM DIMMs required for your desired
configuration, do the following.
1. On the satellite chassis, locate the memory board slots.
2. Hold the 4 GB memory board by its corners, with the DIMM slots facing
up.
Installing Memory in the 4 GB Memory Board
19