Installing Dimms On The Memory Board - HP D7171A - NetServer - LPr Upgrade Manual

6. Hold the memory board by the corners, and carefully pull the
board from its slot until the edge connectors are free of the system
board connectors.
7. Place the memory board component-side up on a firm, anti-static
surface for protection.

Installing DIMMs on the Memory Board

Follow these steps to install a DIMM in a slot on the memory board.
CAUTION
1. With the board resting flat, component-side up, on a firm
anti-static surface, orient it so that the edge connector faces left.
2. Remove a DIMM from its container, handling the module by its
edges. Lay it on an anti-static surface.
Wear a grounded anti-static wrist strap connected to
the NetServer chassis before installing DIMMs.
Use only DIMMs acquired from HP. Contact HP
Customer Support for a list of qualified DIMMs. HP
will not support configurations that use non-HP EDO
DIMMs.
21