HP D7171A - NetServer - LPr Installation Manual page 21

Chapter 2
4. Locate the slot where you will install the 128 SDRAM DIMM, and spread
the two DIMM retaining clips outward. (Figure 2-12).
Retaining
Clip
5. Align the notches on the SDRAM DIMM with the notches on the socket.
6. Hold the SDRAM DIMM so that the front edge faces straight down into
the connector (at a 90 angle to the memory board).
Installing Memory in the 4 GB Memory Board
Figure 2-12. Installing a DIMM Module
Retaining
Clip
17