Tools Required; Power-Down Procedure - HP D7171A - NetServer - LPr Installation Manual

Chapter 2

Tools Required

To remove or install a memory board, first remove the satellite chassis lower fan
module and the rear access panel. These tools are required for removal and
installation of accessories:
Number 1 Phillips head screwdriver
An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.

Power-Down Procedure

Power to the satellite chassis must be turned off before removing or installing the
4 GB memory boards.
1. Save your existing system configuration.
2. Log off all users, shut down all networking software, applications, and the
operating system.
3. Press the DC power switch on the HP NetServer's control panel (Figure
2-4).
8
Installing Memory in the 4 GB Memory Board