Intercom Operation; Making An Auto Intercom Call - RCA 2112 User 's guide User Manual

3. To cancel, press the do not disturb button again.
NOTE: You can press the do not disturb button and activate the
function immediately, even when there is an incoming call ringing in,
or during call screening after the call is taken by the answerer.

Intercom Operation

(Applicable only with additional handsets)
The intercom feature allows you to have a conversation with another
registered handset without tying up the telephone line, allowing you to still
receive incoming calls.

Making an Auto Intercom Call

1. Make sure the handset is OFF (not in TALK mode).
2. Press the delete/int/conf button on the handset .
3. Use the touch-tone pad to select the handset you want to page.
NOTES:
a) If the user has not entered the paged handset number within a
few seconds, the handset displays a paged handset number list (i.e.
Handset 2, Handset 3, Handset 4, ) if Handset 1 is paging the handset .
b) Even if the handset has not been registered with all 4 handsets,
the paging list displays all handset numbers.
c) If the user has selected a paged handset number that has not
been registered, the handset emits an error tone and asks the user
to retry again.
4. A long beep is heard and then the two handsets are immediately
connected. Receiving handset shall immediately come into the auto
intercom mode that both "microphone" and "speaker " of this receiving
handset shall be enabled such that the user of receiving handset can freely
talk and listen to the conversation.
5. When finished, press the END button or delete/int/conf button on either
handset to deactivate the intercom.
NOTE: The system i s expandable up to 4 handsets ( by purchase
of optional Model 2110 handset with recharge cradle). When 4
handsets are registered, the system can handle 2 separate intercom
operations at once, for example, 1st handset intercoms with 2nd
handset while 3rd handset intercoms with 4th handset.