From the Answerer Menu:
1. Press the caller ID-volume ( or ) button to scroll to the SECURITY
CODE sub-menu.
2. Press mute/menu OK button to enter the menu. The screen displays
SECURITY CODE 1 2 3.
3. Use the touch-tone pad to enter your new -digit security code. The default
setting is 123.
4. Press the mute/menu OK button to confirm. You will hear a confirmation
tone and the screen displays the new security code.
NOTE: If you make a mistake, use the delete/int/conf
button to delete the security code and begin again.
Speaker Volume
Use the volume (
comfortable level. L1 is the minimum speaker volume and L8 is the maximum.
Voice Instruction
If you need additional assistance, press the repeat button in standby mode
and follow the voice instructions.
Recording the Outgoing Announcement
For best results when recording, you should be about nine inches from the
microphone, and eliminate as much background noise as possible.
You may record an outgoing announcement for the current answerer mode or
choose the default for your current outgoing announcement.
1. Make sure the answering system is ON.
2. Press and hold the announce button until the speaker announces "RECORD
ANNOUNCEMENT FOR RECORD MESSAGES MODE AFTER THE TONE ".
3. Begin speaking after you hear the beep.
4. Release the button when you finish your announcement.
NOTE: If you choose not to record an outgoing
announcement, a default announcement plays instead.
To return to the default announcement after you have
recorded your own outgoing announcement , press and hold the
announce button and release it when you hear the beep. Or,
press the delete button while the announcement is reviewing.
Sample Outgoing Announcement
Hi, this is (use your name here), I can't answer the phone right now,
so please leave your name, number and a brief message after the
tone, and I'll get back to you. Thanks.
or
) buttons to adjust speaker volume on the base to a