NetVanta 1335 Series Hardware Installation Guide
5.
UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as mounting
options, supplying power to the unit, and installing option cards. These instructions are presented as follows:
•
•
•
•
•
•
•
•
For information on configuring a specific application, refer to the configuration documents provided on
ADTRAN's Knowledge Base at http://kb.adtran.com, or the
Knowledge Base article 2219).
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
The NetVanta 1335 Series is intended to be installed, maintained, and serviced by qualified
service personnel only and should be installed in a restricted access location as described
in UL/IEC 60950-1.
Ethernet and PoE cables are intended for intra building use only. They should not be run
outside the building.
Tools Required
The customer-provided tools required for the hardware installation of the NetVanta are:
•
Ethernet cables
•
Network cables (module dependent)
•
DSX-1 cable (T1/FT1 + DSX-1 module only)
•
DBU cable (dial backup functions require an optional DIM)
•
Phillips-head screwdriver
To access the CLI of the NetVanta, you will also need a VT100 terminal or PC with
terminal emulation software and a console port cable. Instructions on how to access the
CLI are given in the
2219).
61700515E2-34C
AOS Command Reference Guide
AOS Command Reference Guide
Copyright © 2011 ADTRAN, Inc.
Unit Installation
(ADTRAN's
(ADTRAN's Knowledge Base article
39