Supermicro Supero X8DTH-6F User Manual page 75

Confi gure SATA#1 as
This feature allows the user to select the drive type for SATA#1. The options are
IDE, RAID and AHCI. (When the option-RAID is selected, the item- ICH RAID
Code Base will appear.)
ICH RAID Code Base (Available when the option-RAID is selected)
Select Intel to enable Intel's SATA RAID fi rmware to confi gure Intel's SATA RAID
settings. Select Adaptec to enable Adaptec's SATA RAID fi rmware to confi gure
Adaptec's SATA RAID settings. The options are Intel and Adaptec.
ICH AHCI Code Base (Available when AHCI is selected for Confi gure
SATA#1 as)
Select Intel AHCI ROM to confi gure SATA#1 to support Intel AHCI ROM. Select
BIOS Native Module to confi gure SATA#1 to support BIOS Native Module mode.
The options are Intel AHCI ROM and BIOS Native Module.
SATA#2 Confi guration (This feature is available when the option-IDE is
selected for SATA#1)
Selecting Enhanced will set SATA#2 to native SATA mode. The options are Disabled,
and Enhanced.
IDE Detect Timeout (sec)
Use this feature to set the time-out value for the BIOS to detect the ATA, ATAPI
devices in the system. The options are 0 (sec), 5, 10, 15, 20, 25, 30, and 35.
Primary IDE Master/Slave, Secondary IDE Master/Slave, Third IDE Master,
and Fourth IDE Master
These settings allow the user to set the parameters of the slots indicated above.
Press <Enter> to activate the following submenu screen items. Set the correct
confi gurations accordingly.
Type
Select the type of a device connected to the system. The options are Not In-
stalled, Auto, CD/DVD and ARMD.
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk drive.
In the LBA mode, the maximum drive capacity is 137 GB. For drive capacities
over 137 GB, your system must be equipped with a 48-bit LBA mode addressing.
If not, contact your manufacturer or install an ATA/133 IDE controller card that
supports 48-bit LBA mode. The options are Disabled and Auto.
4-11
Chapter 4: AMI BIOS