Special Features; Pc Health Monitoring - Supermicro Supero X8DTH-6F User Manual

X8DTH-6/X8DTH-6F/X8DTH-i/X8DTH-iF User's Manual
1-3

Special Features

Recovery from AC Power Loss
BIOS provides a setting for you to determine how the system will respond when
AC power is lost and then restored to the system. You can choose for the system
to remain powered off (in which case you must hit the power switch to turn it back
on) or for it to automatically return to a power- on state. See the Advanced BIOS
Setup section to change this setting. The default setting is Last State.
1-4

PC Health Monitoring

This section describes the PC health monitoring features of the X8DTH-6/X8DTH-
6F/X8DTH-i/X8DTH-iF. All have an onboard System Hardware Monitor chip that
supports PC health monitoring. An onboard voltage monitor will scan these onboard
voltages continuously: CPU1 Vcore, CPU2 Vcore, CPU1 Vtt, CPU2 Vtt, CPU1
DIMM, CPU2 DIMM, 1.1V, 1.5V, 1.8V, 3.3V, 12V, 5V, 3.3 Vsb, and VBAT. Once a
voltage becomes unstable, a warning is given or an error message is sent to the
screen. the user can adjust the voltage thresholds to defi ne the sensitivity of the
voltage monitor.
Fan Status Monitor with Firmware Control
The PC health monitor can check the RPM status of the cooling fans. The onboard
CPU and chassis fans are controlled by Thermal Management via BIOS (under
Hardware Monitoring in the Advanced Setting).
Environmental Temperature Control
The thermal control sensor monitors the CPU temperature in real time and will turn
on the thermal control fan whenever the CPU temperature exceeds a user-defi ned
threshold. The overheat circuitry runs independently from the CPU. Once it detects
that the CPU temperature is too high, it will automatically turn on the thermal fan
control to prevent any overheat damage to the CPU. The onboard chassis thermal
circuitry can monitor the overall system temperature and alert users when the chas-
sis temperature is too high.
Warning! To avoid system overheating, be sure to provide adequate air
fl ow to the system.
System Resource Alert
This feature is available when used with Supero Doctor III in the Windows OS
1-10