Supermicro Supero X8DTH-6F User Manual page 33

Installing and Removing DIMMs
Notch
Release
Tab
X8DTH
Rev. 2.01
To Install: Insert module vertically and press down
until it snaps into place. Pay attention to the align-
ment notch at the bottom.
Release Tab
To Remove:
Use your thumbs to gently push the release
tabs near both ends of the module. This should
release it from the slot.
2-11
Chapter 2: Installation
DIMM DDR3
Note: Notch
should align
with the
receptive point
on the slot
3
Notch
Release
Tab
Release Tab