Solving Basic Printer Problems; Printer Control Panel Display Is Blank Or Displays Only Diamonds - Lexmark E360d Series User Manual

84 Replace PC Kit
The photoconductor kit is exhausted. Install a new photoconductor kit.
88 Cartridge is low
Press to clear the message.
88 Replace toner
Try one or more of the following:
•
Replace the toner cartridge.
•
Press the arrow buttons until Continue appears, and then press

Solving basic printer problems

If there are basic printer problems, or the printer is unresponsive, make sure:
•
The power cord is plugged into the printer and a properly grounded electrical outlet.
•
The electrical outlet is not turned off by any switch or breaker.
•
The printer is not plugged into any surge protectors, uninterrupted power supplies, or extension cords.
•
Other electronic equipment plugged into the outlet is working.
•
The printer is turned on. Check the printer power switch.
•
The printer cable is securely attached to the printer and the host computer, print server, option, or other network
device.
•
All options are properly installed.
•
The printer driver settings are correct.
Once you have checked each of these possibilities, turn the printer off, wait for about 10 seconds, and then turn the
printer back on. This often fixes the problem.
Printer control panel display is blank or displays only
diamonds
The printer self test failed. Turn the printer off, wait about 10 seconds, and then turn the printer back on.
If Performing Self Test and Ready do not appear, turn the printer off and contact Customer Support.
Troubleshooting
110
to clear the message and continue printing.