Lan1/2 Enable/Disable; I2C To Pci-Express Slot; Watch Dog Enable/Disable - Supero SUPERSERVER 6015T-INF User Manual

LAN1/LAN2 Enable/Disable
Change the setting of jumper JPL1 to
enable or disable the LAN1 port and
JPL2 to enable or disable the LAN2
port on the serverboard. See the table
on the right for jumper settings. The
default setting is enabled.

I2C to PCI-Express Slot

2 2
JI C1/JI C2 allows you to enable the
I 2 C bus to communicate with the PCI-
Express slot. For the jumpers to work
properly, please set both jumpers to the
same setting. If enabled, both jumpers
must be enabled. If disabled, both
jumpers must be disabled. See the
table on the right for jumper settings.

Watch Dog Enable/Disable

JWD enables the Watch Dog function,
a system monitor that takes action
when a software application freezes
the system. Jumping pins 1-2 will
have WD reboot the system if a pro-
gram freezes. Jumping pins 2-3 will
generate a non-maskable interrupt for
the program that has frozen. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
BIOS.
Chapter 5: Advanced Serverboard Setup

LAN1/2 Enable/Disable

Jumper Settings (JPL1/2)
Jumper Setting
Pins 1-2
Pins 2-3
I 2 C to PCI-Express Slot
Jumper Settings (JPI
Jumper Setting Defi nition
Closed Enabled
Open Disabled
Watch Dog
Jumper Settings (JWD)
Jumper Setting
Pins 1-2
Pins 2-3
Open
Note: when Watch Dog is enabled, the user must
write their own application software to disable the
Watch Dog Timer.
5-19
Defi nition
Enabled
Disabled
2 C1/JPI 2 C2)
Defi nition
Reset
NMI
Disabled