Installing A Hard Drive Into A 5.25-Inch Drive Bay - HP Workstation xw6000 Hardware Reference Manual

Hardware Upgrades

Installing a Hard Drive into a 5.25-Inch Drive Bay

✎
2–16
4. Connect the ends of the cables to the appropriate system board
connectors. To locate the appropriate drive connectors, see
"System Board Components" in Chapter 1.
5. Reassemble the workstation.
To install a 3.5-inch hard drive into a 5.25-inch, half-height drive bay,
the drive must be housed in an adapter.
Prior to installing a SCSI device, read the section "SCSI Devices" in
Appendix B.
To install the drive and adapter:
1. Shut down the operating system properly, then turn off the
workstation and any external devices. Disconnect the power cord
from the grounded AC outlet.
2. Remove the workstation access panel. See "Removing the
Workstation Access Panel" in this chapter.
3. Remove the front bezel. See "Removing the Front Bezel" in this
chapter.
Hardware Reference Guide