Locating The Hardware Screws; Installing A Hard Drive; Installing A Hard Drive Into A 3.5-Inch Drive Bay - HP Workstation xw6000 Hardware Reference Manual

Hardware Upgrades

Locating the Hardware Screws

Installing a Hard Drive

Installing a Hard Drive into a 3.5-Inch Drive Bay

✎
2–14
Your workstation has extra guide screws stored behind the front bezel.
Install these screws to ensure that the drive lines up correctly in the
drive bay. Some options use M3 metric hardware. HP supplied metric
screws are black.
Identifying the guide screws
The following sections provide instructions for installing a hard drive
into a 3.5-inch drive bay and into a 5.25-inch drive bay.
Prior to installing a SCSI device, read the section "SCSI Devices" in
Appendix B.
To install a hard drive into a 3.5-inch drive bay:
1. Shut down the operating system properly, then turn off the
workstation. Disconnect the power cord from the grounded
AC outlet.
2. Remove the workstation access panel. See "Removing the
Workstation Access Panel" in this chapter.
3. Remove the front bezel. See "Removing the Front Bezel" in this
chapter.
Hardware Reference Guide