Hardware Upgrades
✎
Removing an Expansion Board
2–24
5. Slide the expansion board into the socket. Press firmly on the
board so that the whole connector seats properly in the socket.
If installing an AGP expansion board, the board must have an ATX
bracket.
Installing an expansion board
6. Replace the screw to secure the board in the socket.
7. Reassemble the workstation.
8. Reconfigure the workstation, if necessary.
To remove an expansion board, reverse the steps in the previous
section. When reversing these steps:
■
Be sure to store the board in antistatic packaging.
■
Install an expansion slot cover to close the open slot.
Hardware Reference Guide