Table of Contents
Advertisement
installing the driver in a new OpenDesktop 3.x
system
In this scenario, you are installing SCO UNIX OpenDesktop 3.x
on a single drive or array group. To install the driver
1
Start up the system with the N1 disk.
2
At the boot prompt, type
defbootstr link=dpti4
3
When prompted for the SCO BTLD disk, insert the driver
disk you created earlier.
4
Insert the N1 or Boot Disk again when prompted.
5
Insert the N2 disk when prompted. In the Hardware Roster,
the following line should appear:
% adapter type=dpti ha=0 id=7 channel=0, PCI
6
Continue the installation according to the SCO
documentation.
installing the driver in a new OpenServer 5.0x
system
In this scenario, you are installing SCO UNIX OpenDesktop 3.x
or OpenServer 5.0x on a single drive or array group. To install
the driver
1
Start up the system with the SCO UNIX boot disk.
2
For OpenServer 5.0x, at the boot prompt type
defbootstr ahslink=dpti5
For OpenServer 5.04 or later, at the boot prompt type
defbootstr link=dpti5
3
When prompted for the SCO BTLD disk, insert the driver
disk you created earlier (refer to
4
Insert the N1 or Boot Disk again when prompted.
5
Insert the N2 disk when prompted. During the Hardware
Roster, the following line should appear:
installing the driver
page
3-26).
3-27
Advertisement
Table of Contents
