Adding The Controller To An Existing Windows 95/98/Me System - Adaptec Workstation x1000 Installation Manual

Adaptec RAID Installation Guide
22
If you system contains multiple Adaptec RAID controllers,
repeat Steps
should ask you to reboot when this action is completed.
23
The Device Manager should now show an Adaptec I
Host Adapter in the SCSI and RAID Controllers section.
24
Optional: Using a text editor, remove the following entries
from your
device=i2oddl.sys
device=dptcdrom.sys
25
Optional: Using a text editor, remove the
your
autoexec.bat
procedure, these
may no longer be needed.
adding the controller to an existing Windows 95/
98/Me system
In this scenario, you are adding an Adaptec RAID controller to an
existing Windows 95/98/Me system. To install the driver
1
Install and configure your Adaptec RAID controller and
hard drives according to the instructions in
2
Start up the system. During startup, press Ctrl+A to start
SMOR. Use SMOR to create the RAID. For details, refer to
using SMOR on page
3
Restart the system.
4
If Windows prompts for a driver to support a PCI card, go to
Step 11.
3-16
14 through 21
file:
config.sys
file. When you complete the installation
config.sys
2-11.
for each controller. The system
mscdex
and
autoexec.bat
O RAID
2
entry from
file entries
Chapter 2.