Table of Contents
Advertisement
Adaptec RAID Installation Guide
installing the driver in a new system with
Windows 95 (OEM SR2 – version 95B)
In this scenario, you are installing a bootable Adaptec RAID
controller in a new system with Windows 95 (OEM SR2 version).
Note: If your version of Windows predates SR2, you must
install windows and upgrade to SR2 before installing the
Adaptec RAID controller.
To install the driver
1
Install and configure your Adaptec RAID controller and
hard drives according to the instructions in
2
Start up the system. During startup, press Ctrl+A to start
SMOR. Use SMOR to create the RAID. For details, refer to
using SMOR on page
3
Shut down the system and reboot from a bootable DOS disk.
4
Run
fdisk
appropriate size.
5
Mark the primary DOS partition Active.
6
Reboot the system from the DOS disk.
7
Perform a system format by typing format c: \s.
8
Remove the DOS disk and insert the driver disk you created
earlier (refer to
9
Remove the driver disk.
10
Reboot the system.
11
Insert the Windows 95 OEM SR2 CD.
12
Type d :\setup where d: is the letter assigned to your CD
drive.
13
Follow the Windows installation prompts. When Windows is
fully installed, proceed to the next step.
3-14
2-11.
and create a primary DOS partition of an
page
3-11).
Chapter
2.
Advertisement
Table of Contents
