Windows Nt - Adaptec Workstation x1000 Installation Manual

d
When you see the Adaptec splash screen, click Create
Driver Disk. Then, click the appropriate operating
system.
e
Insert a floppy disk and click OK. The system creates the
driver disk.
2
Shut down the system and remove the Adaptec RAID
Installation CD.
3
Restart the system.
4
Click the Windows Start button, select Run, and type
a:\w2kprep.exe
5
Remove the driver disk.
6
Insert the Windows 2000 CD and run the
Setup copies some files and then reboots the system.
7
When the system is restarting, a blue screen appears after
the hardware detection message. When prompted to install
a third-party driver, press F6
Note: You only have 5 seconds to press the F6 key during
the installation startup. A hardware detection message
appears when F6 is active. Press F6 at this time;
otherwise, you must restart the installation process to
complete this procedure correctly.
8
When prompted, insert the driver disk you created in
and select Adaptec I
Windows 2000. Press Enter and follow the instructions
displayed.

Windows NT 4.0

The following driver installation scenarios exist for

Windows NT 4.0:

installing the driver in a new system with only one controller
on page 3-6
.
.
O RAID Host Adapter Driver for
2
installing the driver
program.
setup.exe
Step 1
3-5