HP Vectra VE 5/xxx - 2 User Manual page 74

4 The HP Setup Program
Using the HP Setup Program
Setup Item
Configuration
Integrated Peripherals
Parallel port
Parallel port Mode
Serial port A
Serial port B
Flexible disk controller
Flexible disk drive A
Flexible disk drive B
A & B flexible disk swap
62 English
Default
378h IRQ7 Enables/disables the parallel on-board port at
the specified address. "Disabled" frees
resources used by the port.
Centronics TM Sets the operating mode of the parallel port.
3F8h IRQ4 Enables/disables the on-board serial port A at
the specified address. "Disabled" frees
resources used by the port.
2F8h IRQ3 Enables/disables the on-board serial port B at
the specified address. "Disabled" frees
resources used by the port.
Enabled Enables or disables the on-board flexible disk
controller.
1.44MB,3 1/2" Selects the flexible disk drive type.
Not Installed Selects the flexible disk drive type.
Disabled Enable this option only if you need to boot on
flexible disk B. Then flexible disks A and B
will be swapped.
Action