Installing Mass Storage Devices; Configuring A Device After Installation - HP Vectra VE 5/xxx - 2 User Manual

NOTE

Installing Mass Storage Devices

You can install additional mass storage devices, if you need extra mass
storage space for your application software.
The PC has one internal drive shelf for a hard disk drive. If your PC
already has a hard disk drive, this shelf will be occupied.
There are three front access drive shelves. The top shelf is occupied by
a 3.5-inch flexible disk drive. The middle shelf can be used to install a
5.25-inch flexible disk drive or a CD-ROM drive. The bottom shelf can
be used to install a 1-inch high, 5.25-inch or 3.5-inch wide front access
device, or to install a second hard disk drive internally.
Your PC has the following connectors on the system board which can
be used by mass storage devices:
a flexible disk drive connector, which supports up to two flexible disk
•
drives
two Enhanced IDE device connectors.
•
You can install a non-IDE hard disk drive or CD-ROM device, but it will
need an accessory board and driver software (usually supplied with the
device). Contact the product vendor for further information.

Configuring a Device After Installation

After installing a second IDE drive or a flexible disk drive, you will need
to run the Setup program to configure the device. Refer to "The HP
Setup Program" on page 55 for details of how to do this.
3 How to Install Accessories In Your PC
Installing Mass Storage Devices
English 33