Table of Contents
Advertisement
Microphone module
Description
Microphone module (includes cable)
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Disconnect the wireless antenna cables from the WLAN module (see
6. Remove the following components:
a. Hard drive cover (see
b. Mini Card compartment cover (see
c. Optical drive (see
d. Keyboard (see
e. Keyboard cover (see
f. Speaker assembly (see
g. Display assembly (see
Remove the microphone module:
1. Release the tabs 1 built into the display enclosure.
2. Release the microphone receiver 2 from the display enclosure. The microphone receiver is secured by
two-sided tape.
3. Remove the microphone cable 3 and receiver from the display enclosure.
Reverse this procedure to install the microphone module.
Maintenance and Service Guide
"Battery" on page
"Hard drive" on page
"RTC battery" on page
"Optical drive" on page 4-20
"Keyboard" on page
4-21)
"Keyboard cover" on page
"Speaker assembly" on page
"Display assembly" on page
4-7).
4-8)
4-12)
4-24)
4-26)
4-28)
Removal and replacement procedures
Spare part number
517629-001
"WLAN module" on page
4-14).
4–35
Advertisement
Table of Contents
