Table of Contents
Advertisement
17. If it is necessary to replace the display hinges, loosen the four Phillips PM2.0×3.0 screws 1 that secure each
hinge to the display panel.
✎
Remove and install the screws in the sequence indicated on the display hinge bracket.
18. Remove the display hinges 2. The Display Hinge Kit is available using spare part number 486737-001.
19. If it is necessary to replace the wireless antenna transceivers and cables, remove the Phillips PM2.5×3.0
screw 1 that secures each transceiver to the display enclosure.
20. Detach the wireless antenna transceivers 2 from the display enclosure. The transceivers are secured by a foil
wrapping.
21. Release the wireless antenna transceivers and cables from the clips 3 built into the display enclosure.
22. Remove the wireless antenna transceivers and cables 4 from the display enclosure. The wireless antenna
transceivers and cables are available using spare part number 502979-001 for models with discrete graphics
subsystems, and spare part number 489066-001 for models with UMA graphics subsystems.
Reverse this procedure to reassemble and install the display assembly.
Maintenance and Service Guide
Removal and replacement procedures
4–33
Advertisement
Table of Contents
