Table of Contents
Advertisement
Removal and replacement procedures
Webcam/microphone module (select models only)
Description
Webcam/microphone module
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Disconnect the wireless antenna cables from the WLAN module (see
6. Remove the following components:
a. Hard drive cover (see
b. Mini Card compartment cover (see
c. Optical drive (see
d. Keyboard (see
e. Keyboard cover (see
f. Speaker assembly (see
g. Display assembly (see
Remove the webcam/microphone module:
1. Lift the webcam/microphone module 1 as far from the display enclosure as the webcam/microphone module
cable allows.
2. Disconnect the webcam/microphone module cable 2 from the webcam/microphone module.
3. Remove the webcam/microphone module.
Reverse this procedure to install the webcam/microphone module.
4–34
"Battery" on page
"Hard drive" on page
"RTC battery" on page
"Optical drive" on page 4-20
"Keyboard" on page
4-21)
"Keyboard cover" on page
"Speaker assembly" on page
"Display assembly" on page
4-7).
4-8)
4-12)
4-24)
4-26)
4-28)
Spare part number
487287-001
"WLAN module" on page
Maintenance and Service Guide
4-14).
Advertisement
Table of Contents
