Table of Contents
Advertisement
3. Turn the computer right-side up, with the front toward you.
4. Disconnect the following cables from the system board:
1 TouchPad cable with zero insertion force (ZIF) connector
2 USB cable
5. Remove the two Phillips PM2.5×6.0 screws 1 that secure the top cover to the base enclosure.
6. Lift up the front edge of the top cover until it releases from the base 2.
7. Remove the top cover 3.
Reverse this procedure to install the top cover.
Maintenance and Service Guide
Removal and replacement procedures
4–37
Advertisement
Table of Contents
