Removing And Replacing The Battery - HP T5145 - Thin Client - Tower Troubleshooting Manual

Removing and Replacing the Battery

Before beginning the replacement process, review
on page 7 for procedures you should follow before and after installing or replacing hardware.
WARNING!
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1. Locate the battery on the system board.
2. To release the battery from its holder, gently push the metal guard that extends above one edge
of the battery very slightly toward the rear of the unit, and then lift the battery out (1).
NOTE:
Figure 2-8
3. To insert the new battery, align the replacement battery with the positive side toward the rear of
the unit. Slide one edge of the battery into the slot and push down until the guard snaps over the
edge of the battery (2).
HP encourages you to recycle used electronic hardware, HP original print cartridges, and rechargeable
batteries. For more information about recycling programs, go to
"recycle".
Before removing the side access panel, ensure that the thin client is turned off and the
Be careful not to bend the metal guard.
Removing and replacing the internal battery
Batteries, battery packs, and accumulators should not be disposed of together with the general household
waste. In order to forward them to recycling or proper disposal, please use the public collection system
or return them to HP, an authorized HP partner, or their agents.
The Taiwan EPA requires dry battery manufacturing or importing firms, in accordance with Article 15 or
the Waste Disposal Act, to indicate the recovery marks on the batteries used in sales, giveaways, or
promotions. Contact a qualified Taiwanese recycler for proper battery disposal.
General Hardware Installation Sequence
http://www.hp.com
Installing Thin Client Options
and search for
13