Replacing The Metal Side Cover And Side Access Panel - HP T5145 - Thin Client - Tower Troubleshooting Manual

2. Lift the metal side cover, rear side first, off the unit (2).
Figure 2-4

Replacing the Metal Side Cover and Side Access Panel

To replace the metal side cover:
1. Slip the front edge of the metal side cover under the lip on the chassis and lower the cover until it
snaps into place (1).
2. Align the screw holes of the metal side cover with the chassis holes and insert and tighten the four
screws (2).
Figure 2-5
To replace the access panel:
1. Align the tabs on the access panel with the slots in the metal side cover and place the access panel
on the side of the unit, offset about 3 mm (1/8 inch) toward the top of the unit (1).
2. Slide the panel toward the bottom of the unit until the cover is flush with the bottom panel of the
chassis (2).
Removing the metal side cover
Replacing the metal side cover
Removing and Replacing the Side Access Panel and Metal Side Cover 11