Installing the mid-weight slides in round-hole or
square-hole racks
NOTE: If the rear slide brackets must adjust to shallower
or deeper third-party columns, see "(Optional) Adjusting
the mid-weight outer slide assemblies (on page 3)."
1.
Install the mid-weight inner slides ("Installing the mid-weight
inner slides" on page 1).
2.
Mark your rack columns using the mid-weight slide-mounting
alignment tool ("Marking your rack columns using the mid-
weight slide-mounting alignment tool" on page 1).
3.
Install the mid-weight outer slide assemblies by aligning the
center pin of the mid-weight outer slide assemblies with the
markings on front and rear of the rack columns.
4.
Proceed to "Sliding the server into the mid-weight outer slide
assemblies (on page 2)."
Installing the mid-weight slides in threaded-hole
racks
NOTE: If the rear slide brackets must adjust to shallower
or deeper third-party columns, see "(Optional) Adjusting
the mid-weight outer slide assemblies (on page 3)."
1.
Install the mid-weight inner slides ("Installing the mid-weight
inner slides" on page 1).
2.
Mark your rack columns using the mid-weight side-mounting
alignment tool ("Marking your rack columns using the mid-
weight slide-mounting alignment tool" on page 1).