Sliding The Server Into The Mid-Weight Outer Slide Assemblies - HP C8000 - Workstation - 0 MB RAM Installation Instructions Manual

Mid-weight slide kit

Hide thumbs Also See for C8000 - Workstation - 0 MB RAM:

Table of Contents

Enlarged version

Remove the front and rear brackets from the mid-weight outer

slide assemblies, and save the four nuts.

Align (1) the top hole of the front brackets with the markings on

the front of the rack columns. Secure the front brackets to the

rack using M5 x 16-mm screws (2).

Transfer the markings from the front of the rack columns to the

sides of the rack columns, and install the mid-weight outer slide

assemblies by aligning the threaded side studs with the

markings on the rack columns.

Secure the front of the outer slide assemblies to the rack

columns using the nuts from step 3. Secure the rear of the mid-

weight outer slide assemblies to the rack columns using M6

flathead screws and the nuts from step 3.

Proceed to "Sliding the server into the mid-weight outer slide

assemblies (on page 2)."

Sliding the server into the mid-weight outer

slide assemblies

WARNING: Two people are needed to align and install

the server properly. Do not install the server with the mid-

weight inner slides extended.

Slide the server into the mid-weight outer slide assemblies.

Connect the cables to the server.

Install and secure the cable management arm to the mid-weight

outer slide assemblies.

Table of Contents

5069-6371