Page of 3
   
HP 10000 Series Rack Airflow
Optimization Kit
Installation Instructions
© Copyright 2002, 2007 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
Part Number 302980-003
July 2007 (Third Edition)
Overview
The HP 10000 Series Rack Airflow Optimization Kit enables you to
install foam rail gaskets into your HP 10000 G2 Series 22U, 36U,
42U, and 47U 600-mm (24 in) wide racks and into 42U 800-mm
(31 in) wide racks to improve separation between hot and cold
aisles in the data center.
Callout
Description
1
600-mm (24 in) or 800-mm (31 in) perforated
floor gasket (1)
2
Foam rail gasket roll (4)
Installing foam rail gaskets
IMPORTANT: This option kit is only compatible with HP
racks that are 600-mm (24 in) or 800-mm (31 in) wide.
1.
Cut the foam rail gasket to fit the size of your rack.
2.
Insert the foam rail gasket into the rack front door on both sides
of the rack.
3.
Insert the foam rail gasket into the space between the 19-in
mounting rails and the vertical frame on both sides of the rack,
with the closed cell side of the foam rail gasket facing the front
of the rack.

Advertising

   Related Manuals for HP 245161-B22 - 10642 42U Rack Shock Pallet

   Summary of Contents for HP 245161-B22 - 10642 42U Rack Shock Pallet

  • Page 1: Kit Contents

    Overview HP 10000 Series Rack Airflow The HP 10000 Series Rack Airflow Optimization Kit enables you to Optimization Kit install foam rail gaskets into your HP 10000 G2 Series 22U, 36U, 42U, and 47U 600-mm (24 in) wide racks and into 42U 800-mm Installation Instructions (31 in) wide racks to improve separation between hot and cold aisles in the data center.

  • Page 2

    Gently push the foam rail gasket into the space until it is flush Gently push the foam rail gasket into the space between the with the vertical frame. racks until it is flush with the vertical frame. Installing foam rail gaskets between racks (Optional) See the HP Baying Rack Option Kit for specific information on baying racks.

  • Page 3

    Remove the protective tape from the bottom edge of the floor gasket, and apply it to the bottom of the rack with the adhesive strip facing the front of the rack. Installation is complete.

This manual also for:

10000 series

Comments to this Manuals

Symbols: 0
Latest comments: