Auto Configure - Kyocera FS-C5100DN User Manual

User Guide
specify the memory setting, PDL (Page Description Language), settings for the user,
administrator settings for passwords and more.

Auto Configure

Auto Configure detects the installed device options on the printing system if it is
connected over a network. It detects printing system devices such as input devices,
output devices, and hard disk size. Then it updates the Device options list in the
Device Settings tab. Auto Configure keeps the printer driver's Device Settings
consistent with the actual printing system devices. This is a manual process and can
be run at any time.
Note: Not all installed devices are detected by using Auto Configure. Before
selecting OK in the Device Settings tab, check the settings to make sure they are
correct.
The Auto Configure feature cannot communicate with a printer if the printer is
powered off or in the middle of startup. In these cases, the driver displays the
message, Please verify that the printer is powered on and ready to print.
If the driver's model is different from the actual printer model at the port, Auto
Configure stops the device settings update and displays the message, The selected
TCP/IP port is connected to a network printer that does not match the current printer
driver. In order to use the Auto Configure feature, select a TCP/IP port that matches
the current printer driver.
Under the following conditions the Auto Configure tool cannot communicate with the
printing system:
• The Windows XP firewall prevents the communication. It opens a Windows
Security Alert dialog box with this message: Do you want to keep blocking this
program? (Keep Blocking, Unblock, Ask me Later).
The Microsoft Windows XP Firewall settings can be changed to allow communication
between the printing system and your computer. The default setting for Windows XP
Service Pack 2 is for the Windows Firewall to be set to On.
Printer Properties
2-2