Thick Paper; Colored Paper; Preprinted Paper; Recycled Paper - Kyocera FS-C5100DN Advanced Operation Manual

Handling Paper

Thick Paper

Fan the stack of paper and align the edges before loading them in the MP
tray. Some types of paper have rough edges on the back (those are
created when the paper is cut). In this case, put the paper on a flat place
and rub the edges once or twice with, for example, a ruler to smooth them.
Feeding rough edged paper may cause paper jams.
Note If the paper jams
even after you smooth
it out, load the paper in
the MP tray with the
leading edge raised up
a few millimeters as
shown in the
illustration.
If you use thick paper
quite often, we
recommend to use optional paper feeder PF-510.

Colored Paper

Colored paper should satisfy the same conditions as white bond paper,
refer to Paper Specifications on page 1-2. In addition, the pigments used
in the paper must be able to withstand the heat of fusing during the
printing process (up to 200 °C or 392 °F).
Note If you use colored paper quite often, we recommend to use
optional paper feeder PF-510.

Preprinted Paper

Preprinted paper should satisfy the same conditions as white bond paper,
refer to Paper Specifications on page 1-2. The preprinted ink must be able
to withstand the heat of fusing during the printing process, and must not
be affected by silicone oil. Do not use paper with any kind of surface
treatment, such as the type of paper commonly used for calendars.

Recycled Paper

Select recycled paper that meets the same specifications as the white
bond paper except for whiteness, refer to Paper Specifications on page
1-2.
Note Before purchasing recycled paper, test a sample on the
machine and check that the printing quality is satisfactory.
Coated Paper
Coated paper is created by treating the surface of the base paper with a
coating that provides higher printing quality than plain paper. Coated
paper is used for particularly high quality printing.
The surface of high-quality or medium-quality paper is coated with special
agents that improve ink coverage by making the paper surface smoother.
These agents are used either to coat both sides of the paper or just one
side. The coated side appears slightly glossy.
1-11