Kyocera FS-C5100DN Advanced Operation Manual page 50

>Quick Copy
?Harold
>Quick Copy
?Arlen
>Arlen
?Report
>Report
Copies
>Report
Copies
>Report
Delete
2-26
Using Proof-and-Hold
When you print multiple copies, this mode first prints one copy so that you
can proof it before continuing to print the remaining copies. Since you can
proof the printouts before printing the remaining copies, wastage of paper
can be reduced.
The printer prints one copy and, at the same time, saves the print job on
the hard disk/RAM disk. You can also change the number of copies when
resuming printing from the operation panel.
When the printer is turned off, all stored jobs will be deleted.
Note Refer to KX Printer Driver User Guide for the driver
settings.
Printing Remaining Copies of a Proof-and-Hold Job
1
Press while Job Box > is displayed.
2
Press
entered in the printer driver (Harold, in this example) also appears.
3
Press [OK]. A blinking question mark (?) appears before the user
name.
4
Press
example.
5
Press [OK]. The job name entered in the printer driver (Report, in
this example) appear with a blinking question mark (?) before the
letters.
6
Press
Note If you selected All Files, this process is applied to all
the documents in the Quick Copy/Proof-and-Hold.
7
Press [OK]. The number of copies to be printed can be set. To
increase the copy count, press
001
.
Note If you selected All Files, press
displayed to set the number of copies. When using the number of
copies specified with print job, select Copies ---.
8
Press [OK] to finalize the copy count. The printer prints the specified
number of copies for the job.
Deleting a Proof-and-Hold Job
1
Follow steps 1 through 6 in the above section to let the title of the job
to be deleted displayed.
2
When the title of the job to be deleted is displayed, e.g. Report,
press [OK]. The cursor (_) below the copy count starts to blink.
001
3
Press
or repeatedly until >Quick Copy appears. The name
or to display the desired user name, Arlen, in this
or to scroll to the desired job title.
to decrease the copy count, press
repeatedly until Delete appears below the title.
after Copies --- is
Using the Operation Panel