Connecting To A Wired Network; Connecting To A Wireless Network - Xerox 6015/NI User Manual

Connecting to a Wired Network

Note: Available on WorkCentre 6015N/NI Color Multifunction Printer only.
To connect the printer to a wired network:
1. Ensure that the printer is turned off.
2. Attach a Category 5 or better Ethernet cable from the printer to the network or router socket. Use an
Ethernet hub or router, and two or more Ethernet cables. Connect the computer to the hub or router
with one cable, then connect the printer to the hub or router with the second cable. Connect to any
port on the hub or router except the uplink port.
3. Attach the power cord, then plug in the printer and turn it on.
4. Set or automatically discover the network IP address of the printer. For details, see
Address of the Printer

Connecting to a Wireless Network

Note: Available on WorkCentre 6015NI Color Multifunction Printer only.
A wireless local area network (LAN) provides the means to connect two or more devices in a LAN without
a physical connection. The printer can connect to a wireless LAN that includes a wireless router or wireless
access point. Before connecting the printer to a wireless network, the wireless router must be configured
with a service set identifier (SSID), a passphrase, and security protocols.
Resetting Wireless Settings
If the printer was previously installed in a wireless network environment, it could retain setup and
configuration information.
To prevent the printer from trying to connect to the previous network, perform the following steps:
On the printer control panel, press the System button.
1.
2. To select Admin Menu, press the arrow buttons, then press OK.
To select Wireless, press the arrow buttons, then press OK.
3.
4. To select Reset Wireless, press the arrow buttons, then press OK.
5. To select Yes, press the arrow buttons, then press OK.
on page 53.
WorkCentre 6015 Color Multifunction Printer
Installation and Setup
Assigning the IP
47
User Guide