Table of Contents
Advertisement
Remote Control Unit
Connection
The switch functions of the camera recorder can be
configured using the remote control unit.
* Remote control units supported: RM-LP25U, RM-LP55U,
and RM-P57U
1
Connect the remote control to the camera recorder.
Connect the remote cable of the remote control unit to the
[REMOTE] terminal on the terminal area of the camera
recorder.
RM-LP25U
Note :
● Turn off the power before connecting.
2
Turn on the power of the camera recorder.
3
Set the operate switch of the remote control unit to
ON.
Memo :
● For details on functions that can be operated using the
remote control unit, refer to [List of Remote Control Unit
Functions] (A Page 117 ).
[REMOTE] Terminal
Precautions for Using the Remote
Control Unit
● When the switches of the camera recorder and remote
control unit are operated at the same time, the switch
operation of the remote control takes priority over that of the
camera recorder.
● Focus and zoom operations cannot be performed using the
remote control.
● The shutter speed may vary slightly from the value displayed
on the camera recorder.
● Shutter speed when the frame rate of [Frame & Bit Rate] is
24p
When the frame rate of the camera recorder is set to 24p ,
the shutter speed cannot be set to 1/60 using the remote
control unit. Even if the shutter speed is set to 1/60 , the
actual speed is 1/48 . (A Page 71)
● Auto White function
When the camera recorder is in Media mode, Auto White
does not function even when it is operated using RM-LP25U.
Advertisement
Table of Contents
