JVC HM700U - Camcorder - 1080p Instruction Manual page 45

Error message
If the white balance adjustment is not correctly completed,
one of the following messages will appear for about 5
seconds.
Error Message
NG : OBJECT
ERROR : LOW LIGHT
ERROR : OVER LIGHT
White Paint Adjustment
You can fine-tune the white balance saved in Memory A or
Memory B.
* Adjust [White Paint R]/[White Paint B] in [Main
Menu]B[Camera Process]B[White Balance] (A Page 79)
When [AWB] is selected, the normal white paint adjustment
value is cleared. However, you can also set to keep the value
even when [AWB] is executed. (A Page 79)
Automatic White Balance Mode (FAW:
Fulltime Auto White balance)
You can assign FAW (Fulltime Auto White balance) to any
of the three positions on the [WHT.BAL.] selection switch.
Configure the setting with [FAW] in the [Camera
Function]B[Switch Set...] menu. (A Page 74)
Set the [FULL AUTO] switch on the camera recorder to ON
to enter FAW mode. White balance is automatically adjusted
according to the color temperature of the lighting on the
object.
White balance switching with the [WHT.BAL.] selection
switch is disabled.
Memo :
● When [White Balance] in the [Camera Function]B[FULL
AUTO...] menu is set to SW Set , you can switch the
white balance with the [WHT.BAL.] selection switch on the
camera recorder. (A Page 75)
Note :
● The accuracy of [FAW] is inferior to that of Auto White
Balance.
● When the power of the camera recorder is turned on with the
[FAW] mode selected, it takes about 15 seconds for the
colors to stabilize.
Status
The object used is defective.
Displayed when there is not enough
white color on the object, or when the
color temperature is not suitable.
Use another white object and adjust
the white balance again.
Insufficient illumination.
Displayed when the lighting is dark.
Increase the lighting and adjust the
white balance again.
Excessive illumination.
Displayed when the lighting is too
bright. Decrease the lighting and adjust
the white balance again.