Removing The Stand Column; Installing A Wall-Mount Bracket; Tv Components; Accessories - Dynex DX-32L100A11 User Manual

4
DX-32L100A11
3 Align the locators on the stand column with the locating holes on
the stand, then secure the stand to the column with the four M5
screws (provided).
Table edge
4 Carefully lift the TV into an upright position.
To remove the stand, perform these steps in reverse order.

Removing the stand column

You must remove the stand column before you can wall-mount the TV.
Note: Your TV may differ from the illustrations shown.
To remove the stand column:
1 Lay the TV (screen down) on the edge of the table or bench. Make
sure that you put a soft cloth or cushion between the table or
bench and the TV.
2 Remove the four screws holding the stand column to the TV, then
remove the stand column.

Installing a wall-mount bracket

If you want to attach the TV to a wall-mount bracket (not provided), you
should first remove the stand pedestal, if it is already attached.
To install a wall-mount bracket:
1 Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV is not scratched.
2 Remove the pedestal stand.
3 Remove the stand column. See "Removing the stand column" on
page 4.
4 Secure the wall-mount bracket to the back of your TV using the
four M6 screws provided with the bracket.
Locators
Four M5 screws
Stand
Stand column

TV components

Accessories

Make sure the following accessories are included in the box with your
TV:
• Remote control
• Composite video & audio cable
• AC power cord
• AAA batteries (2)
• Stand
• Quick Start Guide

Front

Item Name Description
Remote control Receives signals from the remote control.
1 sensor Do not block. For more information, see
"Aiming the remote control" on page 7.
Power indicator Lights red when your TV is in standby mode.
2
Flashes red when your TV is turned on, then
turns off when the TV stabilizes.
TV components