Installing A Device In A Front Access Bay - HP Kayak XM600 User Manual

2 Installing and Replacing Hardware Parts in Your PC Workstation

Installing a Device in a Front Access Bay

NOTE
Installing a Device in a Front Access Bay
If the PC has two processors installed, you may not be able to install some
5.25-inch devices (such as a CD-R/W drive) in the lower front shelf. If this
is the case, install the longer of the two 5.25-inch devices in the top shelf.
Removing the Front Access Drive Cage
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover and the front bezel (refer to page 22
for instructions).
3 Remove the retaining screw from the front access cage, and slide it
forwards until it stops.
4 Disconnect the power and data cables from the installed drives.
5 Lift the front access cage upwards and out from the PC. Place the cage
on a table/desk top.
Installing the Device
1 Remove the 5.25-inch plastic filler plate. Use a screwdriver to unclip the
two latches located on the left-hand side of the filler plate, then pivot it
out. Store the filler plate in a safe place for future use
hurt your fingers when you remove the plate.
2 If the new device has a tray, attach it to the front access cage. Some
devices may require an HP-supplied tray before they can be installed.
The tray is available as an accessory. CD-ROM drives do not require a
tray.
36
.
Take care not to