Completing The Installation Of A Mass Storage Device - HP Kayak XM600 User Manual

2 Installing and Replacing Hardware Parts in Your PC Workstation

Completing the Installation of a Mass Storage Device

When an IDE Drive
Is Installed
When a SCSI Hard
Disk Drive Is
Installed
When a CD-ROM,
CD-RW or DV-Drive
is Installed
When a Floppy Disk
Drive Is Installed
Completing the Installation of a Mass Storage Device
1 Switch on the PC Workstation.
2 To verify the configuration of your hard disk drive, press F2 to enter
Setup when the HP logo appears. Once in Setup, select the Advanced
menu, then the IDE Devices submenu. In the Primary Master item, check
that the details for the device have been correctly detected by the Setup
program.
3 Press F3 to save and exit Setup.
4 Refer to the operating system documentation for information on
partitioning and formatting a drive.
5 If an IDE drive is removed, switch on the PC Workstation. The system
BIOS will detect that the device is missing. Press F4 to confirm that you
want to remove the device. The system configuration will be updated
automatically.
1 Switch on the PC Workstation.
2 To enter the SCSI Configuration Utility press F6 when prompted during
the PC Workstation's start-up routine.
3 Verify or modify the configuration of your new SCSI hard disk drive.
For more information on configuring a SCSI hard disk drive, refer
to the SCSI Administrator's Guide available on HP's web site at
http://www.hp.com/go/kayaksupport.
4 When configuration is complete, exit the SCSI Configuration Utility and
re-boot the PC Workstation to save any changes.
1 Switch on the PC Workstation and press F2 when the HP logo
appears.
In the Setup program, select the Advanced menu, then the IDE Devices
2
submenu. Check that the CD-ROM drive has been detected on the IDE
channel.
3 Press F3 to save and exit the program.
1 Switch on the PC Workstation and press F2 when HP logo appears.
In the Setup program, select the Advanced menu, then the Floppy Disk
2
Drives submenu, and check that the drive has been detected.
3 Press F3 to save and exit the program
42
.