Replacing The Main Chassis Fan - HP Kayak XM600 User Manual

NOTE

Replacing the Main Chassis Fan

Removing the Fan
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
Remove the PC Workstation's cover (refer to page 22 for instructions).
2
3 From the rear of the PC, use a screwdriver to gently push the two
retaining clips inwards, then lift the fan up and out of the chassis.
4 Disconnect the fan connector from the MAIN_FAN socket on the system
board.
Replacing the Fan
1 Connect the fan connector to the MAIN_FAN socket on the system
board.
Ensure that all cables are clear of the fan and will not easily come into
contact with the fan during normal use or following transportation.
2 The fan unit can only be installed in one way. The distance between the
two retaining clips is shorter at the top than the bottom. Align the fan
clips with their corresponding holes.
3 Gently push the fan downwards until it clicks into place.
4 Replace the PC Workstation's cover (refer to page 23). Reconnect all the
power and telecommunications cables.
2 Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the Main Chassis Fan
43