Replacing The System Board - HP Kayak XM600 User Manual

Replacing the System Board

Removing the System Board
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
Remove the PC Workstation's cover and front bezel (refer to page 23 for
2
these instructions).
3 Disconnect any cables attached to the system board.
4 Move the front access cage forward (described on page 36).
5 Remove the main memory, processor and any accessory cards from the
old system board (described in this chapter).
6 Remove the four screws located near the
processor sockets.
7 Remove the external screw located on
the rear of the PC near the AGP slot
8 Lift the system board out, being careful
not to damage the PC's rear connectors.
9 Unclip the retaining bracket from the
system board. This bracket must be re-
installed on the new system board (refer
to "Installing the New System Board" on
page 46).

2 Installing and Replacing Hardware Parts in Your PC Workstation
.
Replacing the System Board
45