Copy - 3Com 3CRWE876075 User Manual

copy

This command copies a boot file, code image, or configuration file between the
access point's flash memory and a FTP/TFTP server. When you save the
configuration settings to a file on a FTP/TFTP server, that file can later be
downloaded to the access point to restore system operation. The success of the
file transfer depends on the accessibility of the FTP/TFTP server and the quality of
the network connection.
Syntax
copy <ftp | tftp> file
copy config <ftp | tftp>
• ftp - Keyword that allows you to copy to/from an FTP server.
• tftp - Keyword that allows you to copy to/from a TFTP server.
• file - Keyword that allows you to copy to/from a flash memory file.
• config - Keyword that allows you to upload the configuration file from
flash memory.
Default Setting
None
Command Mode
Exec
Command Usage
• The system prompts for data required to complete the copy command.
• Only a configuration file can be uploaded to an FTP/TFTP server, but every
type of file can be downloaded to the access point.
• The destination file name should not contain slashes (\ or /), the leading
letter of the file name should not be a period (.), and the maximum length
for file names on the FTP/TFTP server is 255 characters or 32 characters for
files on the access point. (Valid characters: A-Z, a-z, 0-9, ".", "-", "_")
• Due to the size limit of the flash memory, the access point supports only
two operation code files.
• The system configuration file must be named "syscfg" in all copy
commands.
5-61
Using the Command Line Interface