Snmp; Trap Destination - 3Com 8250 User Manual

SNMP

Use the SNMP page to display and enter a community string for the Simple
Network Management Protocol (SNMP). To communicate with the access point,
the SNMP agent must first be enabled and the Network Management Station
must submit a valid community string for authentication.
You can set up to four trap destinations, each configurable with the IP address
and community string of the trap manager. Additionally, you can enable trap
notification on a per-user basis. An SNMP filter can be defined on a subtree of the
MIB, and then the filter can be applied to selected SNMP users (also called an
SNMP target). The SNMP target includes the trap notification IP address, port
number, SNMP user name, and the filter to be applied.
Select Enable next to SNMP and enter data into the fields as described below.
When you are finished, click Apply.

Trap Destination

Location—Specifies the access point location.
Contact—Sets the system location string that describes the system location.
(Maximum length: 255 characters)
Community Name (Read Only)—Specifies a community string with
read-only access. Authorized management stations are able to retrieve MIB
objects. (Maximum length: 23 characters)
Community Name (Read/Write)—Specifies a community string with
read-write access. Authorized management stations are able to both retrieve
and modify MIB objects. (Maximum length: 23 characters)
Engine ID—Specifies the name for the local or remote SNMP engine.
Trap Destination 1—Select Enable to set up a trap manager to receive these
messages.
IP Address—Fill in the IP address box for the trap manager that will receive
these messages.
Community Name—Fill in the community string box for the trap manager
that will receive these messages. (Maximum length: 23 characters)
Trap Destination 2—Select Enable to set up a second trap manager to
receive these messages.
IP Address—Fill in the IP address box for the second trap manager that will
receive these messages.
Community Name—Fill in the community string box for the second trap
manager that will receive these messages. (Maximum length: 23 characters)
43