Crestron ST-1700C Operation Manual page 28

1-Way Wireless RF Touchpanel
24 • 1-Way Wireless RF Touchpanel: ST-1700C
respective Operations Guide for the control system. These documents are available
from the Downloads | Product Manuals section of the Crestron website
(www.crestron.com). Refer to the following figure for a typical connection diagram
when uploading files.
NOTE: Use a standard DB9 male to female "straight-through" cable.
Typical Connection Diagram when Uploading a Project from the PRO2 or equivalent
NOTE: If the control system in use has a 4-pin network connector rather than a
modular (RJ-11 type) NET connector, use a ST-CBL (sold separately).
NOTE: To make a cable for either configuration, refer to the "Programming Cable
Specifications" diagram after these notes.
NOTE: An adapter such as a CN-RJ11 (sold separately) is required when using the
RJ-11 cable.
NOTE: The RJ-11 (part of ST-PK) and ST-CBL cables can also be found as part
numbers CNSP-585 and CNSP-586, respectively, in the Crestron cable database. The
database can be downloaded from the Downloads | Software Updates | Cables
section of the Crestron website (www.crestron.com).
NOTE: The procedure on the next page uses the ST-CBL.
Crestron ST-1700C
Operations Guide – DOC. 6225A